Informations Réglementaires - HP P1981A Guide D'installation

Informations réglementaires
Part 15 FCC Compliance Statement
This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
Operation environment
For Home and Office use
Notice
This equipment has been tested and found to comply with the limits of Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation, if this equipment does cause
harmful interference radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
! Reorient or relocate the receiving antenna.
! Increase the separation between the equipment and receiver.
! Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
! Consult the dealer or an experienced radio/TV technician for help.
Caution
To comply with the limits for class B digital device according to Part 15 of FCC Rules,
this device must be installed in computer equipment certified to comply with the
Class B limits. All cables used to connect the computers and peripherals must be
shielded and grounded. Operation with non-certified/Shielded cables may result in
radio/TV interference.
Modification
Any modification not expressly approved by the manufacturer of this device could
void the user's authority to operate the device.
PART 68 FCC Compliance Statement
This equipment complies with Part 68 of the FCC Rules. A label is attached to this
equipment that contains, among other information, the FCC registration number and
ringer equivalence number (REN) for this equipment. If requested, this information
must be provided to the telephone company.
An FCC compliant telephone cord and modular plug is provided with this equipment.
This equipment is designed to be connected to the telephone network or premises wir-
ing using a compatible modular jack which is FCC part 68 compliant. Connection to the
telephone network should be made by using standard modular telephone jack type
RJ11.
The REN is useful to determine the quantity of devices that may be connected to the
telephone line and still have all of those devices ring when your telephone number is
called. In most, but not all areas, the sum of the RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to the line, as deter-
Français 21