Urbanears Alby Guide Rapide page 3

4
2
4
1
3
First time setup
1 Open the case and take the earbuds out.
2 Remove the protective plastic strips and put the earbuds
back in the case.
3 Take out the earbuds, wait 5 seconds and put them in
your ears.
4 Select Urbanears Alby from your device's Bluetooth
Touch control
Double tap any earbud
Play/pause, answer a call or hang up
Charging case
Put your earbuds back into the case to recharge, a fully
charged case can recharge both earbuds up to 4 times.
The LED indicator on the case shows its battery level,
from green (full), through orange to red (low). Connect
the case to a USB power source via the included USB-C
cable to charge it. When your earbuds are in the case,
6
they turn off. Taking them out will turn them on and try to
reconnect.
Overview
Earbuds
1 Touch control surface 5 Case battery LED
2 Earbud LED indicator
6 USB-C port for charging
3 Microphone for phone calls
4 Removable ear tips (S/M/L)
5
Pairing with another device
You can easily change from one connected device to
another.
1 Open the Bluetooth menu on the device that your earbuds
are currently connected to and disconnect Urbanears Alby.
2 The earbuds are now in pairing mode and ready to connect.
3 Open the Bluetooth menu on the device you want to
® menu. connect to and select Urbanears Alby.
Resetting your earbuds
If you have problems pairing your earbuds or they become
erratic or unresponsive, perform a hardware reset.
1 Put the earbuds in the charging case.
2 Take out the earbuds of the case.
If the problem persists, perform a factory reset.
Note: This will delete all information about previous
paired devices.
1 Take out the earbuds and put them in your ears.
2 Press and hold the touch control surface on both earbuds
for 7 seconds, until they turn off.
3 Press and hold the touch control surface on both earbuds
for 10 seconds.
Charging case
You will hear the earbuds turn on, initiate Bluetooth pairing
and then power off.
indicator
4 Put your earbuds back in the charging case and they will
be reset to factory settings.
Pairing after factory reset
1 Open the Bluetooth menu on the device that your earbuds
were previously connected to and remove Urbanears Alby.
2 Take out the earbuds, wait 5 seconds and then put them in
your ears.
3 Select Urbanears Alby from your device's Bluetooth menu.
English
5