Publicité
Les langues disponibles
Les langues disponibles
2. Remove the fairing pouch base and drill at the marked
points on the front pocket using an electric drill motor.
• Remove any burrs from the edge of the hole.
Wind the tape around the
electric drill motor. Leave
10 mm from the tip of the
drill motor untapped to
prevent excessive drilling
into the body.
LEFT FRONT POCKET
3. Install the fairing pouch base as shown.
FAIRING POUCH BASE
4 mm SCREWS
2 of 4
ELECTRICAL TAPE
10 mm (.394 in)
ELECTRIC DRILL
MOTOR
(4.5 mm, #16 BIT)
4 mm NUTS
WASHER
LEFT FRONT POCKET
4. Install the fairing pouch as shown.
FAIRING
POUCH BASE
How to Remove Fairing Pouch
WASHER
08L56-MCA-3000-9A
FAIRING POUCH
Pull up and
remove.
© 2005 American Honda Motor Co., Inc - All Rights Reserved.
Publicité
