Measuring Areas - Powerfix Profi PMDL 5 B1 Mode D'emploi

Adding distances together
You can add the measured distances together:
1. Measure the first distance as described.
2. Press the button +/=
measured carries itself over to the lower line.
3. Measure the next distance. The newly measured distance is shown in the
upper line.
4. Once again, press the button +/=
to the old measurement in the lower line.
5. Repeat steps 2 to 4 to add further measurements.
6. When you wish to leave the addition mode, press the button MODE
All values are erased.

Measuring areas

1. Slide the function switch
The display
2. Press the button MODE
3. Press the button READ
the measured length appears and „W" (Width) starts to flash.
4. Press the button READ
appears on the upper line and the result of the area calculation in the
lower line.
Adding areas together
1. Measure an area as described in the section „Measuring areas".
2. Press the button M
is now saved.
3. Press the button MODE
measurement.
4. Measure the next area.
5. Press the button +/=
6. Press the button RM
the lower line.
7. Press the button +/=
the result is shown in the lower line.
8. Repeat the steps 2 to 7 to add in further measurement values.
9. When you wish to leave the addition mode, press the button MODE
All values are erased.
r
. In the display
q
to „DISTANCE".
2
switches itself on.
7
once. In the display
6
, to measure the length. In the upper line
6
to measure the width. The measured width
4
. „M+" appears in the display
7
. The appliance is now ready for the second
r
. A „+" appears in the display
w
. The result of the first measurement is shown in
r
. Both measurements are added together and
2
, „+" appears and the distance
r
. The new measurement is added
2
- 43 -
flashes „L" (Length).
2
. The area measured
2
.
7
.
7
.