iHome iBT65 Guide De Connexion Rapide

iBT65
QUICK BLUETOOTH CONNECTION GUIDE
PAIRING/CONNECTING YOUR BLUETOOTH DEVICE WITH THE iBT65
Whenever the unit is powered ON, the iBT65 will attempt to autolink to a previously paired
device. If no device is paired or to pair a new device, pair the iBT65 by following the steps
below.
iHome iBT65
For iPhone
1. Make sure your Bluetooth device and the iBT65 are fully charged. Turn
on your Bluetooth device and make it "discoverable" by turning on
Bluetooth mode (check in Options or Settings) .
2. Slide the Off/On/Bluetooth Switch on the side of the iBT65 to Bluetooth
position (
in pairing mode.
3. "iHome iBT65" should appear in your device's Bluetooth menu. If "Not
Paired", "Not Connected" or similar message appears on your device,
select "iHome iBT65" to connect it. If prompted for a passcode, enter
"1234" on your device's keypad.
iHome iBT65
4 4. If pairing is successful, the LED will appear solid blue, indicating the
iBT65 is ready to play audio. There should also be an indication on
your device. If no device is successfully paired within 3 minutes, follow
steps 1-3 above to attempt pairing again.
a device, it will attempt to autolink when the device is within range
(about 30 feet) and the iBT65 is on ( ).
). The LED will flash blue and red, indicating the iBT65 is
For other
iHome iBT65
iHome iBT65
Once the iBT65 is paired to