Table des Matières
Publicité
All manuals and user guides at all-guides.com
Inserting a Glue Stick
Insert one glue stick into the rear end of the glue gun
and push it in as far as you can. Press the trigger to
make sure that the stick is solidly pressed against the
heater unit.
Operation
1. Connect the unit to a power outlet. The glue gun
immediately starts heating up. Wait some minutes.
2. Set the glue gun on its wire support and wait until
some glue is molten and appears in the nozzle.
When the trigger is pressed molten glue is forced out
of the nozzle.
3. Put some molten glue onto the dry, clean surface
you want to use and immediately press the work
piece you want to glue down into the molten glue.
The glue solidifies almost immediately and forms an
instant bond. Press the glued parts together for
several seconds.
4. When the stick cannot be pushed any further by the
trigger, put in a new stick. Do not try to take out the
old one, simply put in a new stick.
The old stick remains in the gun until it has been
completely melted when using the unit next time.
Using
7
Publicité
Table des Matières
