Publicité
Les langues disponibles
Les langues disponibles
5.
Loosen the two thumbscrews holding the wiring
compartment cover closed, rotate and lift the cover
free, and carefully slide it out of the way (there is a
safety cable to hold it while the wiring is being
completed).
6.
Carefully flip the cylinder upright and lift the
cylinder up to the mounting channel assembly.
Feed the fixture leads through the threaded hole in
the center of the fixture top assembly. Engage the
running thread, and rotate the assembly a few
times, being sure that the fixture rotates freely and
is not cross-threading (Fig. 3). Pull the fixture leads
out though the wiring compartment opening. Make
sure they hang freely (don't rotate or twist), and
thread the fixture onto the running thread until the
canopy contacts the ceiling. Tighten the thread
clamp screw to lock the fixture assembly onto the
running thread. (Fig. 4)
WARNING: Failure to tighten the thread clamp
screw to lock the fixture assembly onto the
running thread may allow the fixture to turn and
fall!
7.
Make the electrical connections in the fixture wiring
compartment. The line voltage (Black) wire
connects to the two-position connector with the
Red thermal protector wire. The neutral (White)
wire attaches to the empty position on the
connector with the White wires. If provided,
connect the Violet and Gray control wires to an
empty position on the respective connectors with
Violet and Gray wires.
CAUTION: When making these connections, be
careful that no stray strands of wire stick out of
the connectors that might cause electrical
shorts!
8.
After the electrical connections are completed,
replace the wiring compartment cover and tighten
the thumbscrews to complete the wiring of the
fixture.
9.
Once again loosen (do not remove) the two Phillips
screws on opposite sides of the cylinder until the
cylinder housing is free to slide. Slide MC10LED
outer cylinder housing upwards until it seats on the
finned casting.
CAUTION: Do not pinch any wires between the
cylinder housing and any other parts of the
fixture!
10. Be sure the cylinder housing is completely seated,
and tighten the two Phillips screws to lock the
cylinder housing in place.
Note: If the cylinder housing does not fully seat
when closing, you may need to loosen the screws
a little more to slide it closed. This will allow the
ends of the screws to pass the locking slots at the
very end of the slide travel (Fig. 5).
701 Millennium Blvd • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright
2021 06/25/21
,
revision, All Rights Reserved - Printed in U.S.A.
Part No...........................................
ROTATE
LOCKING
SLOT
SLIDE
HOUSING
CLOSED
93052567
Page 2 of 6
RUNNING
THREAD
Fig. 3
FIXTURE
LEADS IN
WIRING
COMPARTMENT
RUNNING
THREAD
FIXTURE
LEADS
Fig. 4
THREAD
CLAMP
SCREW
PHILLIPS
SCREW
Fig. 5
(1 OF 2)
Publicité
