Zephyr Presrv PRB24C01CG Guide D'utilisation, D'entretien Et D'installation page 32

Troubleshooting
Possible Problem
Frost is forming in the
appliance.
The appliance makes
too much noise.
The door will not close
properly.
32
Possible Cause
The environment is too humid.
The ambient temperature is too low.
The door is being opened too
frequently.
The rattling noise may come from
the flow of the refrigerant, which is
normal. As each cycle ends, you may
hear gurgling sounds caused by the
flow of refrigerant in the appliance.
Contraction and expansion of the
inside walls may cause popping and
cracking noises.
The unit is not level or is touching
another appliance.
The appliance is not level.
The door gasket is not installed
correctly.
The gasket is dirty.
The shelves are out of position.
PRB24C01CG Use, Care, and Installation Guide
S I N G L E Z O N E
Solutions
The unit uses an 'auto-defrost'
system, under certain conditions,
manual defrosting may be
required. If frost builds up, you
can try running the refrigerator
on a warmer temperature setting,
minimizing the number of times
you open the door or unplugging
the unit to allow the frost to melt.
It is normal that as each cooling
cycle ends, you may hearing
ratting or gurgling sounds caused
by the flow of refrigerant in the
appliance. The high efficiency
compressor may make a pulsating
or high pitched sound.
Some popping or cracking noises
are normal. They are caused by
expansion and contraction of the
inside walls due to temperature
changes.
Check to make sure the cooler is
level and that it is non in contact
with another appliance or
furniture.
Make sure the appliance is on a
level surface.
Make sure the door gasket is
properly installed.
Clean the door gasket.
Install the shelves correctly.
P R E S R V ™
B E V E R A G E
C O O L E R