Kids Embrace Batman Trotteur Instructions page 8

Attaching the wheels
With the baby walker upside down and fully folded down, insert
9
the two front wheels (E) into each round hole (P) on either corner
at the front of the walker.
Insert the two back wheels into each large round hole (Q) on
10
either corner at the back of the walker.
Check that all the front and rear wheels are properly inserted.
Attaching the seat fabric
Turn the walker the right way up place it on a firm stable surface
11
and open it up fully.
Insert the two plastic tabs on the front of the seat support (C) into
12
the holes on top of the walker body.
Push the back of the seat support (C) down ensuring it clicks
13
into place. Pull the seat support to check it is properly locked in
position.
Place the seat fabric (B) over the seat support (C) and thread
14
one of the plastic clips, on the seat fabric, through the slot in the
seat ring on the upper surface of the walker body.
From the underside of the walker, pull the plastic clip through the
15
slot and fold it over so that it cannot be pulled out again.
Repeat steps 14 and 15 until all clips have been attached, ensuring they
are folded over and cannot be pulled out from the slots.
WARNING: Check the seat is properly attached before using the walker.
DO NOT use the walker if all the tabs are not secured properly. Your child
may fall through if the seat is not fitted correctly.
6