Getting Started - AIPTEK MyNote Bluetooth Manuel

MyNote Bluetooth Manual
Power LED:
Battery Status:
Bluetooth LED:

Getting started

1. Charge the Battery of the Base Unit
2. Prepare the pen
2x
3. Power On
Blink slowly in standby mode; blink quickly during writing.
Blink slowly during charging or when battery is low; steady on when fully
charged.
Blink slowly when bluetooth is on.
Before using MyNote Bluetooth the first time, the battery needs to be charged.
Connect the device with the supplied USB cable trough the USB connector and
the other side to a powered PC, Mac or notebook. After 3 hours the unit is fully
charged and ready to use. Alternative you can use an optional 5V DC USB
charger which can be purchased in Aiptek webshop. (www.aiptekshop.de)
Before first time usage the batteries and pen tip must be installed.
a. Remove the battery compartment cover on top of the pen. Do not
attempt to open the other part of the pen itself. This may cause the
pen to malfunction.
b. Install the two SR41 batteries, with the positive poles (+) facing
up.
c. Close the battery compartment cover.
d. Place the pen tip in the pen and gently push it
The device turns on automatically once you open the folder, the
indicator starts blinking. Put the folder on a flat surface and make sure that
the base unit is located on top of the paper and the holes of the
receiver are not covered.
in until the end is reached. Don't use to much
pressure to avoid damage of the pen.
www.aiptek.eu
EN
Page 5