Installation Instructions; Wall Mount - Southwire L17VP06 Serie Instructions D'installation

INSTALLATION INSTRUCTIONS

L17VP06 & L17VP07 Series 850 Lumen
LED VAPOR TIGHT CEILING MOUNT &

WALL MOUNT

WALL MOUNT
Please read and follow the instructions carefully before trying to install the
fixture. Please retain this instruction sheet for future reference.
MOUNTING:
WARNING: Turn off power supply before installing or servicing fixtures.
NOTE: Make certain that the fixture is connected to a 120 volt power source.
UL approved wire connectors should be used. Be sure no loose strands of
wire are sticking out form under your wire connectors
1-855-SWTOOLS — www.southwire.com
CEILING MOUNT
CEILING MOUNTING:
1. Turn the power off at the fuse or circuit breaker box.
2. Mount housing to either 1/2" hanging conduit or to a surface using the
two tabs.
3. Disassemble fixture: Loosen the two guard screws sticking out at an
angle. Rotate the guard counter-clockwise and lift to remove.
4. Unscrew the lens cover by rotating counter-clockwise.
5. DO NOT TOUCH THE LEDS OR CIRCUIT BOARD. Carefully loosen the
two screws holding the LED light to the junction box. Rotate
counter-clockwise until it separates from the junction box.
See Figure 1.
6. Remove the desired plug in the junction box.
7. Mount the junction box to the surface using the two tabs on the side
of the junction box.
8. ELECTRICAL CONNECTIONS:
Connect the house ground wire to the light's bare copper ground wire.
If the house does not have a ground wire, consult a qualified electrician.
Use a wire connector(included) to connect the black house supply wire to
the light's black wire. Use a wire connector(included) to connect the
white house neutral wire to the light's white wire.
9. Reassemble the light: Carefully push the wires into the junction box. Align
and mount the LED light to the junction box. Do not pinch any wires.
Rotate clockwise and then tighten the screws to fix the LED light to the
junction box. Screw in the lens in a clockwise motion until seated
tightly. Align the guard, rotate clockwise, and tighten the two angled
guard screws
10. Apply silicone caulk (not provided) around the perimeter of the junction
box where it contacts the mounting surface for a moisture seal.
11. Turn the power back on at the fuse or circuit breaker box.
1-855-SWTOOLS — www.southwire.com