Table des Matières
Publicité
Preparation and Use
Checking Oil Supply
After
starting
the
engine, run the chain at
medium speed and see
if chain oil is scattered
off and forms a light
trace.
If the oil supply is not
sufficient do not use the
chain
saw
in
this
Adjusting Screw
condition.
To adjust the chain oil flow, insert a screw- driver into the hole (on the
bottom side of the machine) of the clutch side. Adjust the oil chain flow
according to your work conditions.
Turn the oil adjusting screw counter clockwise in direction MAX for
more chain oil flow and clockwise in direction MIN for less chain oil
flow.
Hint: Refill the oil tank every time when refuelling the saw so there will
be always sufficient chain oil in the tank.
Shut off the Engine
1. Release the throttle lever (10) and allow the engine to run at idling
speed for a while.
2. Push the start/stop switch (8) down.
Operating the Gasoline Chain Saw
It is not necessary to force the chain saw into the cut. Apply only light
pressure while running the engine at full speed and touching the
wooden material. Racing the engine with the chain jammed in the
cutting can damage the clutch system. When the saw chain is caught in
the cut, do not attempt to pull the running machine out by force, but use
a wedge or a lever to open the cut.
14
Publicité
Table des Matières
