Beper P204FER002 Manuel D'instructions page 12

Steam iron Use instructions
To empty the tank, turn the iron upside down on a sink (or similar) and drain all the water still left in the tank.
Otherwise, place the iron in vertical position and reconnect the plug to the electricity. Place the thermostat and
the steam control on and allow the residual water to evaporate in the tank for a few minutes, by pressing the
steam jet button.
Self clean (auto-cleaning)
Fill the water tank to maximum level.
Set the thermostat knob to the maximum position.
Insert the power cord into the wall socket.
Let the iron warm up until the light switches off.
Holding the iron in a horizontal position above the sink, place the steam selector in the maximum position, press
the "Self Clean" button.
The boiling water, the steam and the impurities will be expelled from the holes in the plate.
Unplug the power cord from the power outlet.
Wait until the iron is cold before storing it.
Anti-calc system
A special resin filter inside the water tank softens the water and prevents limescale build-up in the plate. The
resin filter is permanent and does not require replacement.
Note: Do not use chemical additives, scented substances or descaling agents. Failure to comply with the
above mentioned regulations will make a loss of the warranty.
Anti-drop system
With the anti-drop system, even the most delicate fabrics can be ironed perfectly and it is recommended to
always iron at low temperatures.
The plate can cool down to the point where no more steam will come out, but drops of boiling water may come
out and may leave marks or stains. In this case, the anti-drip system is activated automatically to prevent vapo-
rization, so you can iron the most delicate fabrics without risking to damage or stain them.
Cleaning of the iron
Unplug the appliance from the socket.
Remove the plug from the electrical outlet.
To remove scale or starch from the soleplate, use a damp cloth.
Always dry the soleplate after each cleaning.
Clean the body of the iron with a damp cloth without detergents.
Do not use metallic sponge or abrasive detergents.
Storage
Disconnect the power cable from the power outlet, empty the water tank (do this after each use) and let the iron
cool down completely.
Wind the cord around the base.
To protect the soleplate, place the iron in vertical position.
Technical data
Power: 2000-2400W
Power supply: 220-240V~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
12