Table des Matières
Publicité
EN Procedure for the activation of the Access Point
1 -
Connect one end of the RJ45 cable supplied to the Ethernet port of the Access Point .
2 -
Connect the other end of the RJ45 cable to the PC.
3 -
Proceed in one of the following ways:
A
Power the Access Point using the dedicated
power supply.
4 -
Set the PC Ethernet network card to IP address 192.168.1.xxx and mask 255.255.255.0
(WARNING, do not use 192.168.1.220 or 192.168.1.35).
5 -
Open your web browser and enter "192.168.1.220" in the address bar.
6 -
Enter the details found on the label on the base of the ASUS device (user=admin, pwd=admin).
7 -
The configuration page opens. Select the AP tab: if necessary, indicate the network name
(SSID), and the security level, by entering a network password.
8 -
Click FINISH and click OK in the popup window that appears to confirm.
9 -
Wait for the page to update.
10 -
Configuration completed.
It is now possible to disconnect the Ethernet cable from the PC and connect the Access Point to
the F454 Web Server.
Kit Virtual Configurator
Istruzioni d'uso • User guide
B
Power the Access Point through the PC using
the USB connection.
9
Publicité
Table des Matières
