ASROCK Z97 Extreme9 Mode D'emploi page 24

Power LED Header
(3-pin PLED1)
(see p.1, No. 28)
Serial ATA3 Connectors
(SATA3_0:
see p.1, No. 16)
(SATA3_1:
see p.1, No. 18)
(SATA3_2:
see p.1, No. 20)
(SATA3_3:
see p.1, No. 17)
(SATA3_4:
see p.1, No. 19)
(SATA3_5:
see p.1, No. 21)
(SATA3_A1:
see p.1, No. 13)
(SATA3_A2:
see p.1, No. 12)
(SATA3_A3:
see p.1, No. 15)
(SATA3_A4:
see p.1, No. 14)
Serial ATA Express
Connectors
(SATAE_1:
see p.1, No. 23)
(SATAE_2:
see p.1, No. 22)
22
Please connect the chassis
1
power LED to this header
PLED-
PLED+
PLED+
to indicate the system's
power status.
hese ten SATA3
connectors support SATA
data cables for internal
storage devices with up
to 6.0 Gb/s data transfer
rate. If the eSATA port
on the rear I/O has been
connected, the internal
SATA3_A4 will not
function. he SATA3_1,
SATA3_2 are shared
with the SATA Express
connector (SATAE_2).
he SATA3_4, SATA3_5
are shared with the
SATA Express connector
(SATAE_1).
To minimize the boot
time, use Intel® Z97 SATA
ports (SATA3_0) for your
bootable devices.
Please connect either
SATA or PCIe storage
devices to this connector.
he lower SATA
Express connector (the
combination of SATAE_1,
SATA3_4, and SATA3_5)
is shared with the M.2
Socket (M2_2).