American Standard Ovation Curve 2961SWT36 Manuel D'instructions page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1
CORNER STUD INSTALLATION
NOTE: Shower walls must be installed over a combination of studs and OSB board.
Corner Stud Installation for 36" Shower Base
Refer to Corner Stud Installation illustration above for recommended 2x4 location. Shaded 2x4's are required
to be precisely located as shown. Ensure all studs are level and plumb. Fir-out studding if necessary.
Corner Stud Installation for 38" Shower Base
Refer to Corner Stud Installation illustration above for recommended 2x4 location. Shaded 2x4's are required
to be precisely located as shown. Ensure all studs are level and plumb. Fir-out studding if necessary.
1a. Fir-out studding if necessary before installing OSB board to provide correct corner opening for
panels. Ensure corner is plumb and square.
1b. The installation and positioning of additional studs to the corner area will be necessary to provide proper
support for the installation of OSB Board and shower walls.
NOTE: Rough plumbing MUST be installed before walls.
NOTE: If you plan to install a Shower Door, follow manufacturer's instructions and prepare
stud wall accordingly.
9-13/16"
(250 mm)
Required 2x4
8-1/4"
(210 mm)
36"
(914 mm)
12-3/8"
(314 mm)
8-7/4"
(225 mm)
5"(127 mm)
10-13/16"
(275 mm)
Required 2x4
8-1/4"
(210 mm)
12-3/8"
(314 mm)
39"
(991 mm)
8-7/4"
(225 mm)
5"(127 mm)
36"
(914 mm)
5"
9-13/16"
9-13/16"
(127 mm)
(250 mm)
(250 mm)
39"
(992 mm)
5"
10-13/16"
10-13/16"
(127 mm)
(275 mm)
(275 mm)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ovation curve 2961swt38

Table des Matières