ProBreeze PB-V01 Mode D'emploi page 6

Dry Vacuuming
1. Remove the vacuum cleaner from the charging base.
2. Slide the On/Off switch to the On (I) position.
3. Gently move the vacuum cleaner over the area you would like vacuum.
4. Once the area is cleaned slide the On/Off switch to the Off (O) position.
5. Empty and clean the dust tank.
6. Return the vacuum cleaner to the charging base.
Wet Vacuuming
1. Remove the vacuum cleaner from the charging base.
2. Attach the squeegee tool to the end of the dust tank.
3. Slide the On/Off switch to the On (I) position.
4. Move the vacuum cleaner backwards over the wet area you would like vacuum.
5. Once the area is cleaned slide the On/off switch to the Off (O) position.
6. Empty, clean, and dry the dust tank.
7. Return the vacuum cleaner to the charging base.
Notes:
- When wet vacuuming and emptying the dust tank of liquids do not hold the
vacuum cleaner with the dust tank pointing upwards and do not shake it or tilt it to
one side as doing so may cause damage to the motor.
- Always use the squeegee tool when wet vacuuming.
- The squeegee tool will only vacuum liquid when moving backwards.
- Stop vacuuming and empty the dust tank of liquid as soon as the MAX mark on
the dust tank is reached.
- Never leave liquid in the dust tank after wet vacuuming.
Accessories
- Crevice tool – For corners or narrow gaps.
- Brush tool – For delicate surfaces.
- Squeegee tool – For liquids.
To attach the accessories to the vacuum cleaner, insert the chosen accessory into the
nozzle located at the end of the dust tank.
5 | English