Beper P302MAS001 Manuel D'instructions page 8

Rechargeable percussion massager Use instructions
Charging of device
Before first use, the device must be fully charged.
Connect the adapter to the device, by inserting the cable inside the connection hole found on the device, and
then connecting it to the wall socket.
On the device, right below the connection hole, a LED light turns on (red color), while the light indicator on the
adapter turns red; when charging is completed, the light on the adapter turns green: battery is now fully charged.
Full charging requires approx. 2,5 hours, and allows up to 1,5 hours of use (battery life may vary based on inten-
sity level selected and pressure applied during use).
Installing of massaging accessories
Choose the desired massaging accessory based on the area to be treated, and according to your personal
needs.
The device comes with 4 different interchangeable accessories:
Ball accessory: for extended areas of the body, such as pecs, quadriceps, lumbar area, neck and foot plant
U-shape accessory: for a targeted and deep massage of the areas adjacent to the spine and for the scapular area
Bullet accessory: ideal for small areas, such as hands and feet, for the treatment of tense muscle groups and for
the stimulation of trigger points
Flat accessory: for a wide and extensive massage, suitable for all areas of the body
Once the accessory has been selected, insert its connector inside the connection hole found on the front of the
device, by applying a gentle pressure. Make sure that the connector of the accessory is completely inserted
inside the connection hole. Gently pull outwards to remove the accessory.
Important: make sure the device is turned off before inserting/removing a massaging accessory.
Use
Always turn the device on before placing it on the area of the body to be treated.
Press the ON/OFF button once; the device turns on, working at the lowest massaging intensity level.
By repeatedly pressing the ON/OFF button, it is possible to increase intensity, from level 1 (the lowest) to level
6 (the highest). A red LED indicator will turn on above the ON/OFF button, indicating the intensity level selected.
To turn the device off, remove it from the treated area, and press the ON/OFF button 7 times (or until the device
stops working).
It is advisable to start the treatment with the lowest intensity level, and then to gradually increase level, to avoid
any possible bruise or trauma.
Gently move the device around, applying a gentle pressure on the area to be treated, making sure not to stop on
the same spot for more than 60 seconds.
Use the device only on dry and clean skin, free from clothes or other objects that might hinder the movement of
the massaging accessory.
Do not use this device to treat areas above the Adam's apple, in the proximity of the cervical vertebrae (C3 and
C4), on the head, or near the genitalia.
Immediately stop using the device in case of intense pain or discomfort.
It is advisable to turn the device off after 30 minutes of continuous use, to allow the motor to cool down, and then
turn the device back on.
Cleaning and maintenance
Make sure that the device is turned off, and adapter is unplugged from device and wall socket, before proceeding
with any cleaning and/or maintenance operations.
Clean the outer surface of the device with a soft, slightly damp cloth; wipe thoroughly before storing.
Warning: do not immerse device in water. Keep device away from liquids and/or heat sources.
Technical data
2000 mAh lithium battery
Adapter:
Input 100-240V 50/60Hz 0.5A
Output 8.4V ==== 1.0A
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8