Exiting The System Setup Menu; Multi-Zone Operation - Jensen VM9510TS Guide D'utilisateur

VM9510TS
submenu appears in a second row with the selected
option highlighted in light blue.
2. Select a new value by pressing the
22) on the remote control or the or
on the joystick.
3. Confirm your selection by pressing the
buttons (14, 17, 19) on the remote control, or the
button (16, 17) on the joystick. The new value is
highlighted in light blue and setup is complete.
Table 7: ASP Config Menu Features
Setting Options Function
Bass Center 60Hz According to the audio source, select
Freq the Bass Center Frequency to
80Hz
achieve the best Bass effect.
100Hz
130Hz
150Hz
200Hz
Treble Center 10KHz According to the audio source, select
Freq the Treble Center Frequency to
12.5KHz
achieve the best Treble effect.
15KHz
17KHz
Sub.W Filter 80Hz Selecting a crossover frequency sets
a cut-off frequency of the subwoofer's
120Hz
LPF (low-pass filter) and the
"SMALL" speakers' HPF (high-pass
160Hz
filter). The Crossover frequency set-
ting has no effect if the subwoofer is
set to "OFF" and any other speaker is
set to "LARGE".
Sub.W Phase 0D Subwoofer output IN phase
180D Subwoofer output OUT OF phase
NOTE: Depending on your installa-
tion, reversing the subwoofer phase
may increase Bass output.
Bass Q-Factor 1.0 When the Bass Center Frequency is
selected, adjusting the Bass Q-Fac-
1.25
tor alters the sharpness of the Bass
output.
1.5
2.0
BACK Return to previous menu.

Exiting the System Setup Menu

To exit setup mode and resume normal playback, press the
SYS SETUP button (31) on the remote control or the DISP
button (5) on the front panel.

MULTI-ZONE OPERATION

Independent sources can be played simultaneously on the
or buttons (14,
VM9510TS. For example, a video game console can be seen
buttons (18, 19)
on the front screen while DVD video is available to rear
passengers.
, , or
or
NOTE: If DVD is selected as the front source and SD
Card is selected for the rear source, then both sources
will switch to SD Card. If SD Card is selected as the front
source and DVD is selected for the rear source, then
both sources will switch to the DVD source. Since the
multimedia processor is shared between optical and SD
Card media, one of the other can be selected but not
both simultaneously.
Selecting a Source for the Front Zone
To access the FRONT ZONE SOURCE MENU, touch the
TFT screen in the top left corner of the screen.
This menu allows you to select a source for the front zone.
Selecting a Source for the Rear Zone
To access the rear zone SOURCE MENU, touch the top right
corner of the screen, near the Multi-ZONE icon.
Select the source to be directed to the rear Multi-ZONE RCA
outputs.
NOTE: Optical media and an SD Card cannot be selected
from the Multi-ZONE Source Menu simultaneously.
NOTE: The AM/FM tuner graphics will change to a "blue
screen" background when any optical or SD Card media
is selected from the Multi-ZONE menu. In addition, only
the top left (Front Zone Source Menu) and right (Multi-
ZONE Source Menu) quadrants of the touch screen are
active during this mode of operation.
13