Assembly & Installation - PRO-POINT STEEL TRI-FOLD RAMP Mode D'emploi

V1.0
UNPACKING
WARNING! Do not operate the device if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the contents are included.
Contents: • Ramps
ASSEMBLY & INSTALLATION
1. Park the carrying vehicle or trailer on a flat surface capable
of supporting the load. Engage the parking brake and turn
the engine off.
2. Remove the tailgate from a pickup truck for safety.
3. Unfold the ramp until all sections are extended.
4. Place each ramp on the back of the truck or trailer so the
plate has solid contact with the truck/trailer bed. Make sure
the ramps align with the load's wheels.
5. Secure each ramp with a safety chain (#6). Run the chain
through solid part of the vehicle's frame. When tight, slide
the hook through a chain link.
6. Test the ramp by pulling backward on it. Ensure the safety
chains do not allow rearward movement.
7. Clean the ramp's surface of dirt and oil. Dry the ramp to
eliminate a slick surface.
OPERATION
WARNING! Do not ride your machine up or down the ramp as
you may injury yourself or a bystander if the ramp collapses due
to the additional weight or you lose control of the machine.
1. Align the machine's tires with the ramp.
Visit www.princessauto.com for more information
STEEL TRI-FOLD RAMP 8817827
5