Troubleshooting Guide; Cleaning The Unit; Need More Help - RCA DRC99373E Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
Cleaning the Disc
A defective or soiled disc inserted into the unit can cause sound to drop
out during playback.
Handle the disc by holding its inner and outer edges.
• Do NOT touch the surface of the unlabeled side of the disc.
• Do NOT stick paper or tape on the surface.
• Do NOT expose the disc to direct sunlight or excessive heat.
• Clean the disc before playback. Wipe the disc
from the center outward with a cleaning cloth.
• NEVER use solvents such as benzine or alcohol
to clean the disc.
• Do NOT use irregular shaped discs (example: heart shaped,
octagonal, etc.). They may cause malfunctions.

Cleaning the Unit

• Be sure to turn the unit off and disconnect the AC power adapter
before cleaning the unit.
• Wipe the unit with a dry soft cloth. If the surfaces are extremely
dirty, wipe clean with a cloth that has been dipped in a weak soap-
and-water solution and wrung out thoroughly, then wipe with a dry
cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other
chemicals. Do NOT use compressed air to remove dust.
Important Note
• Before transporting the unit, remove the disc from the disc
compartment.

Troubleshooting Guide

No power.
• Ensure the AC power adapter is connected.
• The unit is not turned on.
No sound or only a very low-level sound is heard.
• The volume control is located on the side of the unit – please try
adjusting this.
• The system is in pause mode. Press the
normal play mode.
• The unit is in fast-forward or fast-reverse mode. Press the
to return to normal play mode.
• Make sure the AUDIO/VIDEO output connections are correct.
• The DTS DVD cannot be decoded to have speaker output.
• The unit is too hot; shut off the unit for 30 minutes to cool it down.
No picture.
• The region number of the disc doesn't match the region number of
this unit.
The picture is not clear.
• Clean the disc.
• The disc is scratched.
Severe hum or noise is heard.
• The plugs and jacks are dirty. Wipe them with a cloth slightly
moistened with alcohol.
• Clean the disc.
The disc does not play.
• There is no disc inside ("No Disc" appears on the screen).
• Insert the disc correctly with the playback side facing down.
• Clean the disc.
• A non-NTSC disc has been inserted. The unit and disc region
number are incompatible.
• Condensation may have formed inside the unit due to a sudden
change in temperature. Wait about an hour for it to clear and try
again.

Need More Help?

Please visit online help at
http://www.RCAav.com
EN
button to return to
button
7

Publicité

Table des Matières
loading

Table des Matières