Amsta AMDES112E Notice D'utilisation page 35

Control panel
POWER
In the standby state, the
turn on, the display shows the current humidity. The default fan speed is high, and the default
humidity is 50%. Press again the power button to turn off, the running indicator light goes off and
the compressor stops immediately, then the fan shut down after 30 seconds.
MODE
This dehumidifier has three modes (auto mode, laundry drying mode and sleeping mode). After
turn on the machine, it runs in auto mode as default and the indicator in "AUTO" lights up. The
default humidity is 50%. Press once to switch the mode from one to another, the corresponding
indicator lights up.
● Auto mode:
environmental humidity ≥ set humidity +3%, the fan starts working and compressor starts working
after 3 seconds. When environmental humidity ≤ set humidity -3%, the compressor stops working
and fan stops working after 30 seconds' delay.
● Laundry drying mode:
mode instead of auto mode. The machine continues to run, but the humidity cannot be adjusted.
● Sleeping mode:
lights up. After no operation in 10 seconds, all indicators turn dark gradually and the fan speed is
automatically switched from high to low. Press any button to wake up the indicator.
The default target humidity is 60%. When environmental humidity ≤ 57%，compressor stops
working and the fan shut down after 30 seconds' delay.
When environmental humidity ≥ 63%, the fan starts working and compressor starts working after 3
seconds.
Fan speed and humidity cannot be adjusted under sleeping mode.
When environmental humidity is between 57% to 63%, the device does not run.
HUMIDITY SET
After start the dehumidifier, the display shows the current humidity. Press the button again and set
the humidity. Each press of the button adds 5% and the range of target humidity is 30% to 80%.
After setting 3 seconds, the system confirms the input value and then the machine exits the setting
state, and returns the current humidity. In the laundry drying mode, the target humidity cannot be
changed.
Long Press "HUM SET" button for 3 seconds to display the current ambient temperature.
TIMER
Press the timer button to set the 0–12 hour timing function. The interval is 1 hour. Each time you
press this button, the value increased 1 hours and then the corresponding timing value is displayed
on the screen. The setting value is "00" to cancel the timer function. The indicator turns out. After
operation indicator lights up in red. Press the power button to
The fan speed and humidity can be adjusted under auto mode.
Press the "MODE" button and operates in laundry drying
Press the "MODE" button again, start the sleep function and the indicator
EN-15
hen
W