TELECO AUTOMATION TVSLC868A01 Mode D'emploi page 7

3 - Configuration of the functioning mode
Press P3 button as many times as the desired functioning mode:
Press LED signal
5
both led ON
6 red led ON
7
green led ON
8
red led flashing
The value is automatically memorized 2 seconds after the button release.
Attention: it's not possible to set more than one functioning mode in the device.
4 - Setting the activation threshold
1. Press ATT button until the led are ON, then release.
2. Press ATT button as many times as the desired value:
Press LED signal
1
both led ON
2 red led ON
3
green led ON
4
red led flashing
5
green led flashing
3. Press MEM button to save and exit.
5 - Setting the timer for the timed commands
1. Press MEM button until the led are ON, then release.
2. Press MEM button as many times as the desired value:
Press LED signal
1
both led ON
2 red led ON
3
green led ON
4
red led flashing
5
green led flashing
3. Press ATT button to save and exit.
6 - Memorization of the transmitter
For its proper functioning, EOS needs to be memorized in the memory of the compatible receiver it will
control. In order to execute the memorization please refer to the procedure contained in the receiver's
instructions manual. According to the functioning mode configured at par.3, the transmitter must be
memorized considering the following table:
Function
ON/OFF loads
Screen
Dimmer 100% - OFF
RGB cycle - OFF
TVSLC868A01 (EOS)
Function
ON/OFF loads
Screen
Dimmer 100% - OFF
RGB cycle - OFF
Value (lux)
Value (ore)
deactivated
Memorization procedure
Double channel, press P1 more than 3 seconds
Double channel, press P1 more than 3 seconds
7 channels transmitter, press P1 more than 3 seconds
7 channels transmitter, press P1 more than 3 seconds
Below threshold
ON (CH1)
CLOSE (CH2)
100% (CH1)
START CYCLE (CH6) OFF (CH7)
150
100
50
25
10
2
4
6
8
DOC.:
7
Over threshold
OFF (CH2)
OPEN (CH1)
OFF (CH7)
04/10/16
T624.01
DATE: