1 - Description of the product
1
2 - Functioning of the device
It's possible to configure the activation threshold from 10 to 150lux, with procedure at par.4.
When the measured light level is below this threshold, EOS sends a command; in case of the measured
light level exceeds the threshold of the 50%, EOS sends the opposite command, as well as in case of timed
activation of the receiver (see par.5).
The frequency of control of the light level is set to 20 seconds in the first 13 minutes after power-on or
programming, then it switches to 20 minutes.
The functioning modes are the following:
•
turning on any load (ON/OFF type) if below the threshold, turning off if over the threshold (+50%).
•
screen mode: it closes the application if below the threshold, it opens again if over the threshold (+50%).
•
turning on at 100% of the load if below the threshold, turning off if over the threshold (+50%).
This mode is suitable for dimmer to control led strips or led lights, halogen, fluorescent or incandescent
lamps, heating and ventilation systems.
•
starting the automatic colour cycle in RGB controller if below the threshold, turning off if over the threshold
(+50%).
The configuration of the desired functioning mode can be executed by means of the procedure at par.3.
After the configuration of the device, it can be memorized in one or more compatible receivers.
TVSLC868A01 (EOS)
P1
P2
ATT
MEM
3
4
L1
L2
5
P3
2
6
1 - Light sensor
2 - Batteries (1.5V AA)
3 - Programming buttons
P1: sends ON command
P2: sends OFF command
ATT: threshold configuration
MEM: timer settings
4 - Signal led
5 - P3: transmission mode configuration
T624.01
DOC.:
04/10/16
DATE: