Urmet 1051/107 Guide Rapide page 5

TEST MODE (WALK TEST)
By opening the front panel of the sensor, after having waited for the initialisation phase to finish, the Test Mode is launched and lasts
about 4 minutes. In this condition the cut-off time is disabled, while the LED of the detector of the alarm signal is automatically enabled.
INSTALLATION
1) Installation on flat surfaces
I. Cut seat A and seat B on the bottom (see the image below).
II. Using the holes template, make holes on the surface.
III. Fix the bottom using the special screws in seats A and B.
2) Installation with the 90° support (ref. 1033/018)
First fix the 90° support to the wall with the special screws and then fix the base to the support using seats A and B with the fastening
screws. Re-screw the card to the base.
3) Installation with bracket (ref. 1033/019)
The bracket can be applied horizontally, or directly to the wall with the special screws and anchor bolts, or using the support.
It is possible to orient the base at +/- 45° on a vertical plane and +30°, on the side opposite the "Orientation Arrow", on the horizontal
plane.
I. Puncture seats C and D on the base.
II. Orient the bracket and tighten the bracket blocking screws.
III. Position the base on the bracket with the bracket fastening screws.
1
Seat A
Card fastening
screw
Seat B
Hereby, URMET S.p.A. declares that the radio equipment type: OUTDOOR DUAL TECHNOLOGY DETECTOR WITH CURTAIN
EFFECT 1051/107 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: www.urmet.com.
FR / UK / RUS
LINK TO ACCESS THE PRODUCT TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsability to dispose of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the
time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health
and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
DS1051-018A
2
90° support
Wall fastening
screws
Support
SIMPLIFIED EU DECLARATION OF CONFORMITY
3
Orientation
arrows
bracket Centering
elements
Seat C
Puncture to
access the
bracket
adjustment
screws
Seat D
5