Product Components - Hoover H-FREE Série Manuel D'utilisation

PRODUCT COMPONENTS

A. On/Off Switch and Mode Selector
B. Main Body
C. Foldaway Handle Release Button
D. Handheld Unit
E. Handheld Release Button
F. Handheld Switch On/Off
G. LED Indicator
H. Dust Container Release Button
I. Dust Container
J. Nozzle Release Button
K. Motorized Nozzle
PREPARING YOUR CLEANER
1. Unfold the handle to the main body until it locks in place. [1]
2. Attach the nozzle to the main body, push firmly until it locks in place. [2]
3. To fully charge the appliance, connect the charger jack plug to the battery pack. It will take around
2.5Hrs for 22.2V and 25.9V models and 5 Hrs for 18.5V model. [3]
4. When the product is charging the LED indicator on the handheld will be red and it will turn white when
fully charged.
5. The product holder can be fixed to the wall using the screws provided. [11]
NOTE: To remove the nozzle, press the nozzle release button and pull away from the main body.
NOTE: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner, the On/Off switch must be OFF.
USING YOUR CLEANER
Main Cleaner with Motorized Nozzle
Turn the cleaner on by sliding the On/Off switch to the following settings [4]:
• FLOORS: The cleaner is ready to clean with the main motorised nozzle.
• TURBO: The cleaner is ready to fully power for hard cleaning tasks.
Handheld Cleaner
• Press the handheld release button, lift the handheld unit from the main body. [5]
• Press On-Off button, the cleaner is ready to clean. [6]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product
features with safety protection system on the nozzle.
If the agitator has a blockage or is locked, once actioned, the agitator will stop rotating, the LED lights
on the front of the nozzle will flash 5 times, then go out and the LED indicator on handheld unit will turn
red. [7] If this happens, simply switch off your product and clean the agitator obstruction.
*Certain Models Only.
L. Nozzle Front Led Lights
M. Agitator Release Button
N. Agitator
O. Single Cyclone Vortex Finder
P. Sponge
Q. Pre-Motor Filter
R. Charging inlet
S. Crevice Tool / Dusting Brush
T. Charger
U. Wall mount*
V. Wall Mount Screws*
3
GB