Silence Mode; Technical Speci Cations - x-sense XS01-W Manuel De L'utilisateur

Silence Mode

If you press the silence button during an a larm state, the unit will be in the silence mode for 9 minutes. During the
silence mode, the red LED will fl ash once every 5 seconds. The alarm will enter the normal mode after 9 minutes.
NOTES
1. Mute all other interconnected alarms by pressing the silence button on the initiating smoke alarm. Note that the
initiating smoke alarm cannot be silenced by pressing the silence button on any other interconnected alarm.
2. Under interconnected condition, the initiating smoke alarm cannot be triggered again during the 9-minute silence
duration. However, all other interconnected alarms can be triggered when detecting dangerous smoke levels during
the silence mode.

Technical Speci cations

Power Supply 5-year sealed lithium battery
Sensor Type Photoelectric
Safety Standard EN 14604:2005+AC:2008
Standby Current < 15 uA
Alarm Current < 150 mA
Coverage Area 20-40 m
Best Operating Ambient Temperature 4.4-37.8 °C
Operating Relative Humidity ≤ 85% (non-condensing)
2
12
Alarm Loudness ≥ 85 dB at 3 m @ 3.2 ± 0.3 kHz pulsing alarm
Silence Duration About 9 minutes
Operating Frequency 868 MHz
Maximum Number of Interconnected Units 24 wireless units (only compatible with X-Sense wireless alarms)
Transmission Range Over 250 m in open air
Maintenance
To keep your smoke alarm in good working order, follow these simple steps:
1. Verify the unit's alarm sound and indicator are working properly by testing the unit once a week.
2. As a minimum your smoke alarm should be cleaned once every 3 months: Remove the unit from the ceiling and
clean the alarm cover and vents with your vacuum cleaner fi tted with the soft brush attachment to remove dust and
dirt.
3. Never use detergents or other solvents to clean the unit.
4. Avoid spraying air fresheners, hair spray or other aerosols near the alarm.
5. Do not paint the unit. Paint will seal the vents and interfere with the sensor's ability to detect fi re.
6. Never attempt to disassemble the unit or clean inside. Doing so will void your warranty.
7. When removed, place the smoke alarm back in its proper location as soon as possible, to assure continuous
protection from fi re.
8. When household cleaning supplies or similar contaminants are used, the area should be ventilated.
13