RAB Design SFL-LED Instructions D'installation

SFL-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
•
MIN 75 °C SUPPLY CONDUCTOR
INSTALLATION
Slip Fitter:
1. Remove the bracket mounting screws on the fixture and run the wires
through the bracket.
2. Install the bracket on the fixture.
3. Loosen the 4 locking bolts on the slip fitter, connect the wire correctly and
put the wire into pole. Then fasten the locking bolts between slip fitter and
the pole.
4. Loosen the fixing bolts and adjusting bolts, align the fixture to required
angle. Tighten adjusting bolt and fixing bolts after the angle is confirmed.
Note: Adjustable angle is 0-90°.
Standard Yoke Mount:
1. Fix the FM bracket to the heat sink with M10 screws.
2. Fix it with M6 screws after adjusting to the required the angle.
Highbay Yoke Mount:
1. Align bracket holes with pre-drilled screw hole and fix it.
2. After installation make wiring connections, per wiring diagram.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
May– 2022
FOLLOW
, and these instructions
Page 1 of 2