GEV 001237 Montage page 7

1. Mounting
1a
1b
The movement-detector
reacts to heat. In order
to avoid false switching,
do not mount the equip-
ment
etc., or where the move-
ment-detector will be
subjected to direct sun-
light.
Mounting should only be
done by a specialist.
The work must only be
done when the equip-
ment has been discon-
nected from the electri-
city supply; also be sure
to switch off the electri-
city supply circuit
at the fuse box.
over radiators,
Firstly, separate the frame and sensor. Then screw together accor-
1c
ding to the switch illustration shown below (figures 1-3). Insert the
supply unit into the recessed socket and tighten the fixing claws left
and right. Put the sensor unit on top and fix it by screwing to the
supply unit. The covering frame is
easily placed into
position.
1 2
Replacement of a switch Constant switching readiness:
additional switching-on by
hand is possible (hold down
the opener-pushbutton for
at least 1 sec.)
Fuse Fixing claws
3
Parallel switching for existing
change-over switching