NEC MultiSync IntelliBase iB-USB Mode D'emploi page 12

NEC204 Eng.Fr.manual 10/26/98 10:20 AM
Step 2 Using a Phillips screwdriver, remove the three screws securing
the original base to the monitor. Remove the base by sliding and
lifting as shown in Figure 4A. Save these screws for use in
Steps 6 and 7. Save the original base for possible future use.
Step 3 Using a Phillips
screwdriver, remove
the screw securing
the two base
halves together
as shown in
Figure 4B.
Retain the screw
and black nylon
washer for
use in the next step.
Step 4 Locate Adapter Plate "B"
that is supplied with
the IntelliBase
it to the spindle using the
screw and black nylon
washer that was removed
in Step 3 as shown in
Figure 4C.
Page 12
Figure 4A
ORIGINAL MOUNTING
Figure 4B
Figure 4C
™ and secure
8
RETAIN
THESE
PARTS TO
USE IN
NEW
MOUNTING
NEW MOUNTING
BASE
ADAPTER
PLATE (B)