Ancona COMFORT 10S Guide D'installation Et De Fonctionnement page 9

FLOOR PLUG-IN INSTALLATION
Step 1: Verifying installation parts (Fig. 12)
- Ensure all parts for mounting installation were supplied with your towel warmer.
- If any are missing, please contact us.
Step 2: Installing floor stand posts (Fig. 13)
- Locate the following parts:
o
o: Metal floor stand posts
o m: Screw to set leg in main body
o n: Metal connector that sets the leg on the main body
- Install metal feet o)
o
Position Metal Floor Stand Post o) at the end of a vertical bar insert Connector n) between the main body and
the leg.
o
Insert Screw m) and screw into main body using appropriate sized Allen key.
o
Repeat for each leg.
o
The bottom of the legs can be adjusted by moving the plastic insert (up or down) to
make the stand level.
Step 3: Test the towel warmer
-Remove protective white caps, they are located at the end of each of the vertical bars.
-Turn the switch on to start towel warmer; the On-Off switch is located at the end of one of the posts.
-The towel warmer should reach its pre-set temperature in approximately 15 minutes.
-This towel warmer is designed to operate continuously and can be left on all the times. To save electricity it
can be turned off when not in use.
N
O
Fig. 13
M