Ancona COMFORT 10S Guide D'installation Et De Fonctionnement page 7

WALL PLUG-IN INSTALLATION (cont.)
Step 3: Marking holes for wall mount posts (Fig. 9)
-Take towel warmer with 4 wall leg mounted, as per Step 2.
-Position against the wall where you will want to install the towel warmer.
-Use light pencil to mark legs on the wall (you may want to erase the pencil mark following installation
completion, so make sure you mark lightly).
Step 4: Installing wall posts (Fig. 10)
-If installing on dry wall with no rear beam support (e.g. wood studs):
o Drill a hole in the center of each of the four (4) circles marked on the wall as per Step 3
o Ensure drilled hole is large enough to insert the Plastic Plug provided – part a)
o Insert/screw the Plastic Plug in each of the four (4) holes
o Position wall post b) on top of plastic plug and put in screw c) to set in place
-If installing on surface with rear support, e.g. wood studs (no need for Plastic Plug a)
o Pre-drill small hole in the center of each circle as per Step 3
o Position Wall Post b) on top of pre-drilled hole and put in Screw c) to set in place
Step 5: Mounting main body onto wall (Fig. 11)
-Take main body and position each of the four (4) legs on top of the Wall Post b)
-Once inserted use appropriate sized Allen key to tighten each Set Screw g)
-The installation should be complete
Step 6: Test the towel warmer
-Remove protective white caps, they are located at the end of each of the vertical bars.
-Turn the switch on to start towel warmer; the On-Off switch is located at the end of one of the posts.
-The towel warmer should reach its pre-set temperature in approximately 15 minutes.
-This towel warmer is designed to operate continuously and can be left on all the times. To save electricity it
can be turned off when not in use.
Fig. 9 Fig. 10 Fig. 11