Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Verify that the page select is set on page A, if not press the page select button to select page A.
-
Move the first and second faders all the way up to their maximum value position.
-
Select bank 1 using the bank Up/Down buttons.
-
Press the MIDI/Rec button.
-
Tap scene 1 to store the first scene.
-
Repeat steps 4-7 until all scenes have been programmed into bank 1.
-
Tap the scanner 1 button to turn off the fader control.
-
When finished, disable program mode. You can now manually tap through you have just programmed.
-
Editing A Scene
Program Enable.
-
Press the Bank Up/Down button to select the bank containing the scene you wish to edit.
-
Select the scene you wish to edit by tapping it's scene button.
-
Use the faders and/or joystick to make the desired adjustments to the scene.
-
Once you have completed the changes, tap the MIDI/Rec button.
-
Tap the scene button that corresponds to the scene you're editing. This will override the existing scene.
-
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an existing scene.
Copy Scanner Settings – This setting allows you to copy the settings of one scanner to another
Press and hold down the scanner button you wish to copy.
-
While holding down the button, tap the button of the scanner you wish to copy the settings to.
-
Copy A Scene
Enable Program Mode.
-
Tap the Bank Up/Down button to select the bank containing the scene you wish to copy.
-
Select the scene you wish to copy by pressing it's scene button.
-
Using the BankUp/Down button select the bank you wish to copy the scene to.
-
Tap the MIDI/Rec button.
-
Tap the scene button you wish to copy the scene to.
-
Deleting A Scene
Enable Programming Mode.
-
Press the desired Scene button to select the scene you wish to delete.
-
Press and hold down the Auto/Del button. While holding the button, tap the scene button that corresponds with the
-
scene you wish to delete.
When the programmed scene is delete, all DMX channel values will be set to 0.
-
Deleting All Scenes
With the power off to the unit, press and hold down the Program and Bank Down buttons at the same time.
-
Turn the unit back on, and all scenes should be cleared.
-
Copy A Bank of Scenes
Enable Programming Mode.
-
Tap the Bank Up/Down button until you reach the bank you wish to copy.
-
Tap the MIDI/Rec button.
-
Tap the Bank Up/Down button to select the bank you wish to copy to.
-
Tap the Music/Bank Copy button, all LEDs will briefly flash three times indicating the function has been completed.
-
Press the program button for three seconds to exit programming mode.
-
CHASES
Programming a Chase
Note: You must have already programmed scenes in order to program a chase, this function allows you to cycle through up
to 240 scenes in a preselected order. It is recommended before programming chases for the first time, you delete all
chases in the controller. See Delete All Chases for instructions on how to do so.
Page 15
Publicité
Table des Matières
