Nicols C 512 J II Notice D'utilisation page 15

Fixture #
1
2
3
4
5
6
7
8
9
10
11
12
 Enabling the program mode
To enable program mode, hold the program button for seconds until LED is lit.
Set-up Joystick

Press and hold the "Program" button until LED is lit.
-
Press and hold the "Mode" and "Fine" button at the same time, the assign LED should light. If the reverse LED lights,
-
press "Fine" and "Mode" again to enter assign mode .
Use the bank UP and DOWN keys to select the axis you wish to assign (Pan or TILT).
-
Use the "Tap/Display" button to select 16 or 8 channel mode.
-
Press the button corresponding to the scanner you wish to assign.
-
While holding the mode button press the scene number corresponding to the slider which controls the movement.
-
(Example: If pan is controlled by slider number 4, press and hold the "Mode" button while tapping scene button 4#).
When finished press the "Mode" and "Fine" buttons at the same time again to exit Assign mode.
-
Programming A Scene

Enter program mode (See Enabling Program Mode)..
-
Check the blackout key and verify that the LED is not lit, if it is, press it once to exit blackout mode.
-
Verify that the speed and fade time sliders are positioned at zero.
-
Press the scanner button corresponding to the unit wish to control. You may control more than one scanner at time
-
by pressing the button corresponding to the scanner(s) you wish to program.
Move the faders and joystick to the desired position. If necessary, you may select page B to control channels 9-16.
-
Tap the bank Up/Down button to choose the bank you want to store this scene into. There are a total of 30 banks you
-
can select, you may store up to 8 scenes in each bank.
Once all scanners are programmed into the desired position for the scene, tap the MIDI/Rec button to program this
-
scene into memory.
Tap the scene button you wish to store your scene into. All LEDs will flash three times signifying this operation. The
-
LCD readout will show the bank and scene.
To unselect the scanner(s) you have been programming and switch to another simply press the button of the scanner
-
you have been programming again, deselecting it, and select another scanner.
Repeat steps 2-7 until all scenes have been programmed.
-
If you don't intend to continue programming at this time, press and hold the program button for three seconds to exit
-
program mode. The LED will go out indicating this selection.
Example Scene Program

Program Enable.
-
Tap the Scanner 1 button to turn on its fader control.
-
Digital # Dip Switch Setting
1
17 1 and 5 "On"
33 1 and 6 "On"
49 1,5 and 6 "On"
65 1 and 7 "On"
81 1,5 and 7 "On"
97 1,6 and 7 "On"
113 1,5,6 and 7 "On"
129 1 and 8 "On"
145 1,5 and 8 "On"
161 1,6 and 8 "On"
177 1,5,6 and 8 "On"
SCENES
1 "On"
Page 14