Tasco 269332 Mode D'emploi page 5

6. The Digital Night Vision has a light level sensor on the front of the unit (12) which detects low light conditions and automatically
turns on an infrared illuminator (7) to improve image quality. When the IR light is on, this is indicated by the red LED (9) above
the power indicator. You can also turn the IR illuminator on manually anytime, even if ambient light levels are high, by pressing
and holding the IR switch (8) for a at least two seconds (when you release the switch, you will see the red IR illuminator LED
indicator, confirming the IR illuminator is on now).
7. To increase the brightness of the IR illuminator, press the "+" key (10). This can be used to extend your viewing distance. To
decrease the brightness of the IR illuminator, press the "-" key. This can be helpful in improving the LCD display viewing quality
(by avoiding "wash out") in very low light conditions or complete darkness.
8. While moving from viewing one object to another object, it might be necessary to rotate the objective lens focus wheel and
adjust the IR illuminator brightness in order to achieve the best image quality.
NOTE: A standard tripod mounting socket is provided on the bottom of the unit. Remove the round rubber plug near the center of the bottom
face of the unit and set it aside.
trouBlEsHootInG
unit will not turn on
1. Check that the batteries are installed correctly (2). If the batteries are installed correctly and the batteries are good, then the
green LED indicator light should be on steadily.
2. Check that the power button (3) has been pressed.
Power does not stay on
1. Replace the batteries when they become weak.
2. The unit normally turns off automatically after 2 minutes to conserve battery power. To defeat this, briefly press the IR switch.
Image is not focused.
1. Adjust the objective focus wheel (6) and eyepiece display focus (5).
2. Make sure you are not too close to the object you are viewing.
For any other problems or questions, please contact Tasco Customer Service at:
All manuals and user guides at all-guides.com
(800) 423-3537 • www.tasco.com
5