gas conversion
1
Injector
2
Adjustmen n t of minimum le e vel of the flame e
Control handle
Tap
Sealing ring
injector in place.
Turn the taps down to minimum.
Remove the control hands from taps.
Adjusting by pass screw
‐
For converting 'natural' gas G20 into 'liquid'
gas G30 the screw must be screws down
fully tight
‐
For converting back from G30 into G20, please
rotate the screw in opposite direction to adjust
Tap
the minimum level
‐
Finally check the flame does not go out when
quickly turning the tap from the maximum position
to the minimum position.
Install the control handles on the taps.
Model:
S/N:
G20/20mbar
50/60Hz,Pmax 1W
220-240V
Qn G20:
G30:
G20 20mbar
/
G30/29mbar
6
0359CO1395
0359-14
G31:
II 2H3
G31/37mbar GB Cat.:
+
technical instruction_24