Avanti SED67D0W Manuel D'instructions page 40

•
After cleaning the exhaust hood, check that the flapper or louvers
move freely.
•
Reassemble the exhaust duct and hood, checking that the joints are
secure and sealed.
•
Operate the dryer and verify that the exhaust air is not obstructed in
the vent and that there are no leaks in the system.
•
The outside exhaust hood should be cleaned more frequently to ensure
proper operation.
TROUBLESHOOTING
CHECK THESE SOLUTIONS IF YOUR DRYER...
If your dryer has any problems as followings, you can check as the
solutions listed below before making a service call. This will help you save
time and money.
Problem
The unit
doesn't start.
The unit
doesn't heat.
Doesn't dry.
40
Solution
•
Make sure the door is latched shut.
•
Be sure the power cord is plugged into a live
electrical outlet.
•
Check the home's circuit breaker and fuses.
•
Press the Start/Pause button again if the door is
opened during the cycle.
•
Check the home's circuit breaker and fuses.
•
Select a heat setting other than Air fluff and the
Temp selection is not on "No heat"
•
On a gas dryer, check that the gas supply is on.
•
Clean the lint filter and exhaust duct.
•
Dryer may have moved into the cool-down process
of the cycle.
•
Check all of the above, plus...
•
Be sure the exhaust hood outside the home can
open and close freely.
•
Check exhaust system for lint buildup. Ducting
should be inspected and cleaned annually.
•
Use a 4" rigid metal exhaust duct.
•
Do not overload. 1 wash load = 1 dry load.
•
Sort heavy items from lightweight items.
•
Large, bulky items like blankets or comforters may
require repositioning to ensure even drying.
•
Load may be too small to tumble properly. Add a
few towels.