Kistler 1708B Serie Instructions De Montage page 4

Caution!
Ensure that all connector contacts, threaded holes and
tool recesses are free of dirt and oil.
Connecting Single­Wire Cable with Multi­Channel Connector
1. Cut the single-wire cable to length, allowing enough
free length for service in the assembled mold. Do not
strip the insulation (Fig. 1).
Fig. 1: Cable and connector Type 1708B... separate
2. Feed the cable into the open cut-and-grip contact and
push it fully in.
3. Slip the mounting aid (Fig. 2) over the clamping contact
and tighten it clockwise by hand. This automatically strips
and clamps the cable (Fig. 3). Afterwards you can remove
the mounting aid.
Fig. 2: Mounting aid
4
Fig. 3: Cable installed