General Information; G50035; Assembling; Operating - G3 Ferrari MARINO G50035 Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

- Use original spare parts and accessories only.

- Do not subject the product to strong impacts, serious

damages may result.

Do not connect the electric plug since the installation is not complete.

Do not leave the appliance unattended while it is running. Unplug after each use.

Unplug the unit by pulling the plug and not the power cord.

Do not immerse product in water or other liquids and avoid splashing liquids reach the unit.

Before carrying out any cleaning, disconnect the unit from the electrical outlet.

Before each use, unroll the power cord. Do not insert anything through the protection grids.

Do not obstruct in any way the protection grids.

Place on solid and stable surfaces and away from windows or drafts.

DESCRIPTION G50035

1 Front protection grid

5 Rear protection grid

9 Inclination pin

13 Tilt knob

17 Screw 2

21 Weight

ASSEMBLING

The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the

maximum safety, perform the installation completely before operating.

1) Insert the base (20) in the lower part of the pole (11).

2) Insert the weght (21) under the base, and the fixing ring (22) under the weight (21).

3) Insert the L-shape screw (23) in the hole in the fixing ring (22), and tighten.

4) To mount the motor housing (8) over the pole (11), follow the instructions:

Align the holes on body and pole, and insert Screw 2 (17) in the lower holes. That screw has to be

inserted from right to left, and must be inserted completely, until the final part of the screw, that is

square-shaped, is entered in the hole of the neck (9) of the motor housing.

Insert Screw 1 (14) in the left hole on the head side, and screw it. Fix the head screwing the knob (18)

Slant the head in the desired position and tighten the knob (13)

5) Place the rear grid (5) near the front of motor housing (8) with the metal handle (7) facing upwards. Fit the

holes present in the central part of the grid with the holes on the housing (8) and lock the two parts with the

4 screws (4). Insert the fan (3) onto the shaft (6) and secure the fixing screw of the fan (2) in its hole.

6) Remove the fixing screw (16).

7) Place the front grid (1) in front of the rear grid (5) matching the holes on the grids.

8) Close the locking pins and fasten the two grids tightening the securing screw (16) previously removed.

9) To lift up the fan, loosen the height regulation knob (19), lift the head and tighten the knob.

OPERATING

Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical

outlet. By using control panel (10) the rotation power can be adjusted on different speeds.

0: fan is OFF

OSCILLATION

The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the

pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled. It is recommended

to enable or disable oscillation of the fan only when the unit is off.