Alecto PRO-147 Mode D'emploi page 10

MONITORING
The headphone jack (20) is used to monitor (6.3 mm jack). Use an eight ohms stereo headphone. With the cue
switches (4) it is possible to choose any channel (monitoring two or more channels simultaneously possible). Volume
level is adjustable by slide control 18.
EQUALIZER
This mixer features a 7 channel equalizer (6), which may be used to adjust the tone of the mixed output signal. lf the
equalizer is not needed, depress switch 3 to make a flat output signal.
FADER
Control slide (16) to fade from one channel to another. Channel selection is made with rotar y selectors 15 and 17.
For instance; when fading from channel 1 to channel 2, set switch 15 in position "l and switch 17 in position "2".
When this function is not needed, set both rotar y switches in position "Off".
MASTER
Control slide (19) to adjust the volume of the overall mix.
MONO/STEREO
Selector (22) for mono or stereo output signal.
VU METER
LED vu meter (5). Displays the output level of the complete mix.
LIGHT
BNC connector 12V AC. for lamp holder.
CAUTION: maximum current 100 mA (1,2 Watt).
Exceeding the maximum currect will result in malfunctioning of the mix er, which also may cause a defective power
transformer.
9