Beper 40.968 Manuel D'instructions page 6

Set manicure e pedicure Manuale di istruzioni
PRECAUTIONS
Read the following instructions carefully, since they give you useful safety information about instal-
lation, use and maintenance and help you avoid mishaps and possible accidents. Keep carefully
these instructions.
Remove the packing and make sure that the appliance is intact. If any doubt do not use this ap-
pliance and contact a qualified person. The elements of the packing (plastic bags, polystyrene, etc)
do not have to be accessible to the children, in order to preserve them from danger sources. The
installation must be made according manufacturer's instructions
This appliance is to be destined to its special purpose only. Any other use is to be considered as
improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving
from improper, wrong or incautious use.
Before connecting the appliance make sure that the mains voltage corresponds to the data specified
on the label.
In case of breakdown and/or dysfunction of the appliance, turn off and do not manipulate it.
If you need to make it repair only contact the assistance centre authorized by the manufacturer (to
know the nearest one please call +39045 7134674) and ask for original spare parts. If no respect of
these instructions mentioned above can compromise the security of the device. Before cleaning and
care, unplug the appliance from the socket by pressing the switch or unplug the cord.
Particularly:
Do not touch the appliance with damp or wet hands if the appliance is plugged on the socket ;
Do not use the appliance with naked feet if the appliance is plugged on the socket ;
Do not let children or disabled people use this appliance without supervision ;
Do not let this appliance near to explosive and/or inflammable substances ;
Do not expose this appliance to atmospheric agents such as rain, sun, etc...
USE ADVICE
To keep this appliance in good conditions, it is recommended to turn off the appliance for 15 minutes
when used for 20 minutes to avoid heat.
PRINCIPAL COPONENTS
1. Fine shaping disk
2. Rough shaping disk
3. Fine skin remover
4. Large skin remover
5. Rough grain cone
6. Thin sharp point
7. Thick sharp point
8. Polishing disk
9. Cuticle lifter
10. Unit
11. Charger
12. Case
6