Cleaning Instructions - Palram Palermo 3000 Instructions D'installation

IMPORTANT
Please read these
instructions carefully before you start to assemble this product.
Please carry
out the
steps in
the order
set
out
in
these instructions.
Keep
these instructions
in
a
safe
place for future reference.
»
Care
and Safety advice
Please
follow
the instructions
as
listed
in
this manual.
Sort
the parts and check against the contents
list.
For
safety purposes we strongly recommend the product to
be
assembled by at
least
two
people.
Some parts have metal edges. Please be careful
when handling components.
Always wear gloves, shoes and safety goggles during assembly.
Do
not attempt to
assemble the Gazebo
in
windy
or wet conditions.
Dispose
of
all
plastic
bags safely
-
keep
them
away
from children's
reach.
Keep
children away from the assembly
area.
Do
not attempt to
assemble the Gazebo
if
you
are
tired, have taken drugs,
medications
or alcohol, or
if
you are
prone to dizzy
spells.
When using
a
stepladder or power tools, make sure that you
are
following
the
manufacturer's safety advice.
Do
not climb or stand on the roof.
Heavy articles should not
be
leaned against the poles.
Keep
roof
and gutters clear of snow,
dirt
& leaves.
Heavy
snow load
on
roof
can
damage the Gazebo making it unsafe to
stand below or nearby.
This
product
was designed to be used mainly
as
a
Gazebo.
If color was scratched during assembly it
can be
fixed
with
the
following
tints:
Grey
-
RAL
7012
»
Cleaning instructions
In
order to
clean
the
Gazebo, use
a
mild detergent solution and
rinse
with
cold clean water.
Do
not
use
acetone, abrasive cleaners, or
other
special detergents to clean the panels.
»Tools &
Equipment
T001
(Supplied)
Attention
Please
make sure you install the panels
with the
UV
protected side
out (marked with
"THIS
SIDE
OUT")
and peel the film strip covering
the panels.
Screws and plugs are
not supplied.
Please
tighten
all screws
when completing assembly.
Anchoring this product to the ground
is
essential
to
its
stability
and
rigidity.
It
is
required to complete this stage
in
order for your warranty to
be
valid.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and
assistance.
During Assembly
During assembly
use
a
soft surface below the parts to avoid scratches
and damages.
Steps 3-12:
It
is
recommended to
use
a
carton or other soft material under the lowered
corner
in
order to avoid
scratches and peeling
of
paint.
Step 10:
Optional
-
if
you wish to add Palram's
curtains/netting
-
Please thread
16
of the
plastic clips through the
rail in each
of the four profiles
in
order to hang the
curtains/netting (not supplied).
Steps 10a+12a:
Please
note
that threading of
the screws should
be
done from the outside
Steps 12+14:
Please
note
that threading of
the screws should be made
from the bottom
up.
Step 15b:
Please
add silicone on the inner
area
of part #8327
as
illustrated
Step 21a:
Please
drill
holes in
the panels to be located precisely parallel to the holes
in
profile #7663.
Step 22:
Please level the profile's legs and adapt screws and plugs to your specific
ground type.