Table des Matières
Publicité
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
» Care and Safety advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the contents list.
•
For safety purposes we strongly recommend the product to be assembled by at
least two people.
•
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the Gazebo in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them away from children's reach.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, make sure that you are following the
manufacturer's safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Keep roof and gutters clear of snow, dirt & leaves.
•
Heavy snow load on roof can damage the Gazebo making it unsafe to
stand below or nearby.
•
This product was designed to be used mainly as a Gazebo.
•
If color was scratched during assembly it can be fixed.
» Cleaning instructions
In order to clean the Gazebo, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
» Before Assembly
•
Choose your site carefully before beginning assembly.
•
Sort the parts and check according to the content parts list.
•
Please consult your local authorities if any permits are required prior to constructing
the product.
» Tools & Equipment
T001 (Supplied)
5mm
3/16"
SILICON \
13mm
CAULK
10mm
25/64"
Attention
•
Please make sure you install the panels with the UV protected side
out (marked with "THIS SIDE OUT") and peel the film strip covering
the panels.
•
Please tighten all screws when completing assembly.
•
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
» During Assembly
During assembly use a soft surface below the parts to avoid scratches
and damages.
Step 3: Please note the placement of the short poles.
Optional - if you wish to add Palram's curtains/netting - Please thread 16
of the plastic clips through the rail in each of the four profiles in order to hang
the curtains/netting (not supplied).
Step 4: Please add silicone on the inner area of part #8327 as illustrated.
Step 5: Please make sure the beams are placed correctly in relation to the short
poles.
Step 7: Please make sure you install the panels with the UV protected side
out (marked with "THIS SIDE OUT") and peel the film strip covering
the panels.
Step 12: Please drill holes in the panels to be located precisely parallel to the
holes in profile #8671.
Step 13: Please level the profile's legs and adapt screws and plugs to your
specific ground type. Please note the placement of the gazebo, the short poles
and consequently the slope's direction.
Publicité
Table des Matières
