Sauder Office Port 408365 Mode D'emploi page 13

Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (E) and lay it over your unit.
Make equal margins along all four edges of the BACK (E).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
www.sauder.com/services
Cut-out
E
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(17 used in this step)
408365
1N
NAIL
Page 13