Beper RI.078 Manuel D'instructions page 11

Ceramic Tower Fan Heater Use instructions
• Do not allow water and / or other liquids to enter the product.
• Do not install the product near possible splashes of water (shower,
sink ...)
• If the cable is damaged, contact the service centre immediately.
• This product is for home use only.
• Do not use the product with the knotted power cord.
• Do not turn off the product by pulling the power cord but use the
appropriate button.
• Disconnect the electrical outlet when the product is not in use.
• Do not allow the power cord to come into contact with hot surfaces.
• Do not store the product in closed spaces until it has completely
cooled down.
• Do not connect to external timers.
• Do not install the product outdoors.
• Place the appliance on a flat and stable surface.
• The product is equipped with an overheating protection system,
which will automatically block the operation of the product if it will be-
come too hot. So if the product should stop suddenly it is advisable to
turn it off and let it cool down for a few minutes, then turn it on again.
If the product does not light up again, contact the assistance.
ASSEMBLING OF THE BASE
Connect part A with part B
Connect the base you get with lower part of the ap-
pliance
Fix the base and the appliance with the equipped
screws
11
EN