Sauder Barrister Lane 418705 Mode D'emploi page 7

Step 2 Step
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as
å
shown in the enlarged diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use GOLD 5/16"
å
FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
Edge with
CAM DOWELS
Open end
www.sauder.com/services
U
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Edge with
CAM DOWELS
T
B
3S
T
A
418705
T
Open end
Page 7