G-Systems GSE EC Mode D'emploi page 29

Thank you for purchasing a EC fan controller with LCD display. The EC
fan controller is a speed regulator for ventilated rooms to control exhaust or
exhaust and intake air flow. The function of the EC fan controller involves
maintaining a room at constant temperature and humidity different for day
and night time settings keeping a constant negative pressure in the room to
EN
avoid odors escaping.
The warranty is only valid with a warranty card containing sales date
and stamp from the sales place. Or electronic registered warranty under:
http://g-systems.eu/warranty/. If this is not so, please return immediately
to the sales office!
1. Speed bar
2. Temperature
3. Temperature hysteresis
4. Humidity
5. Humidity hysteresis
6. Minimum speed
7. Maximum speed
8. Day time
9. Night time
10. Nominal value setting
11. Actual temperature
Install the EC fan controller on a wall using the included mounting
template. Install the light- humidity & temperature sensor which comes with
a 4m long cable at a point where you wish to undertake the measurement.
Ensure that this is not directly exposed to a heat source or stream of light in
order to obtain the best precise measurement of the ambient air as
possible.
14 10 26
EC fan controller with LCD display
Foreword
Warranty
Legend
12. Actual humidity
13. Actual fan speed
14. Negative pressure
15. CO
2
16. UP button
17. DOWN button
18. SET/SAVE button
19. Power LED
20. Sensor connection
21. Power supply 12VDC
22. Exhaust air fan (fan1)
23. Intake air fan (fan2)
Instructions