Casals SD75 Mode D'emploi page 10

FITTING THE 'FINGER' BASE (FIG. 1)
- With the help of a screwdriver, remove the front cover of the base-
plate and place the finger base on it.
- Tighten the screw to fix it and place the sanding paper accordingly.
DUST COLLECTION SYSTEM:
- Always use the appliance with the dust collector connected, inhal-
ing dust is harmful to your health.
- Connect the adapter nozzle to the dust suction tank adapter (F).
- Be assured it doesn't fall by moving the appliance.
- To remove the tank, just pull it off.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Assemble the sanding sheet.
- Turn the appliance on, by using the on/off switch.
- Place the appliance against the surface you want to work.
- Slowly move the appliance over the workpiece.
- Do not apply excessive pressure against the workpiece.
- Apply uniform sanding pressure against the workpiece to increase
performance and working life of the sander and the sanding sheet.
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Stop the appliance using the on/off switch.
- Unplug the appliance from the mains.
- Clean the appliance.
MAINTENANCE AND CARE
- WARNING! Always unplug the machine before carrying out work on it.
- The vents should always be kept clean and free of obstacles.
- Clean the machine thoroughly after each use. Blast the motor
regularly with compressed air.
- Check that the mains lead is in good condition. If it is not, take it to
an Official Service Centre to have it replaced.