Princeton Tec Quad Tactical Mode D'emploi

Princeton Tec cares about the environment and
recommends recycling batteries. For more
information about battery recycling, please go
to: www.batteryrecycling.com
Observe proper battery polarity when installing the
batteries. Improper installation of the batteries will
damage the light and void the warranty.
WARNING
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of
storage.
NOTE: Lithium batteries offer extended
constant brightness time, extreme cold weather
performance, and lighter weight. Rechargeable
NiCad or NiMH batteries may result in reduced
brightness due to lower nominal voltage.
The Quad battery compartment has a
waterproof seal. It is important to keep this seal
free from dirt and away from harsh chemicals in
order to preserve waterproof integrity. Inspect
the seal every time batteries are changed. If dirt
is present, wipe gently. With a damp cotton
swab and mild soap until dirt is removed.
NOTE: Some battery types can emit hydrogen
gas, which can create an explosion potential in
sealed devices if it is not vented or removed.
The Quad is equipped with a platinum catalyst
to remove this gas. Upon severe impact, the
catalyst could fracture. If you notice a rattling
sound in the headlamp or gray particles in the
battery compartment, do not use the
headlamp. See the warranty and return policy
for more information.
Switch Operation - See Switch Operation
Diagram
Modes (High, medium, low and flash) are
selected by pressing and releasing the button
within 1.5 seconds of the previous button
press.
Battery Installation
1 2
Changing Lenses
1
Operation
press 1x = Low
press 2x = Med
press 3x = High
press 4x = Flash
Ultrabright
LEDs
There are two ways to turn the Tactical Quad off.
You can cycle through the modes until you reach
off or if more than two seconds has passed since
the previous button press the next press of the
button will turn the light off.
Regulated LEDs
The Tactical Quad uses a sophisticated
current-regulating circuit that maintains initial
brightness as long as the batteries have
sufficient voltage.
Troubleshooting
If the Tactical Quad fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is
confirmed.
• Check circuit board for water (the seal may
have been compromised by improper rear
cover installation). The light will resume
normal operation once the water
is shaken or blown out and the light is left
open until completely dry. If the light has
been contaminated with
salt water, flush the unit with fresh water and
dry as described above.
USA Lifetime Warranty - International
10-Year Warranty
Due to International regulations, Princeton
Tec's lifetime warranty can only be offered to
customers in the USA. Princeton Tec offers a
10-year warranty to our customers outside the
USA. FULL WARRANTY - Princeton Tec
warrants this product to be free from defects in
workmanship and materials under normal use
for as long as you own this product. This
warranty covers all of the component parts of
the product except batteries. This warranty
does not cover deterioration due to normal
wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair.
Princeton Tec will repair or replace parts which
are defective In workmanship or materials. Your
Mise en place des piles
3
Changement de letille
2 3
Fonctionnement
Alkaline Batteries
LOW
4
authorized Princeton Tec Dealer and Princeton
Tec are the only facilities authorized to repair
the product. After (3) unsuccessful attempts to
repair the product, you have the right to elect
replacement of the product or a refund of the
purchase price less allowance for use of the
product. NO INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the
exclusion or limitation of incidental or
consequential
damages, so the above limitations or
exclusions may not apply to you.) This
warranty gives you specific legal rights, and
you may also have other rights which vary
from state to state.
Princeton Tec reserves the right to change
product specifications without notice.
Return Policy
If your light fails to operate, follow these simple
steps:
1) Check batteries. Replace if necessary.
2) Contact Princeton Tec customer service at
800-257-9080 to request an RMA number to
send your light in for repair or replacement. No
warranty repairs will be accepted without an
RMA number.
3) Return the light without batteries to:
Princeton Tec, 5198 Rt. 130, Bordentown, NJ
08505. Postage due and freight collect items
will not be accepted.
2012
Einlegen der Batterien
4
Wechsellinse
4
Betrieb
HIGH
MEDIUM