Steelcase Alimentation modulaire universelle Directives D'assemblage page 18

®
1. Place the block with the power infeed connector port facing
the direction of the power outlet that will power the system.
Use a grey distribution block if power is located at the end of the table.
Use a black splitter distribution block if power is entering from the
center of the tabletop.
NOTE: the distribution blocks should be located based off the central
power units it will connect. When using the black splitter distribution
block, the grey distribution blocks will have their infeed port facing
toward this block.
2. Screw the distribution blocks onto the underside of the tabletop.
The blocks must be located 7"/180mm from the perimeter.
3. Insert jumper cords between distribution blocks, starting with the infeed/jumper ports.
Press until tabs lock into place.
3
Conference Table
1
Infeed Port
User Power
Port
2
2x
Page 18 of 23
P/n 1468305001
Doc # 160136 Rev C
19mm
7/8"